[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: Re: AW: display _request(macname)

From   "Carl Mastropaolo" <>
To   <>
Subject   st: Re: AW: display _request(macname)
Date   Wed, 3 Feb 2010 10:19:45 -0500

Thank you Martin.  I will check this out.


----- Original Message ----- 
From: "Martin Weiss" <>
To: <>
Sent: Wednesday, February 03, 2010 10:17 AM
Subject: st: AW: display _request(macname)


Why even bother to use -_request-? You could simply pass this as an argument
to the -do- command, as in [U], section 16.4.


-----Ursprüngliche Nachricht-----
[] Im Auftrag von Carl
Gesendet: Mittwoch, 3. Februar 2010 16:13
Betreff: st: display _request(macname)


I am modifying a .do file graciously sent by Tirthankar so that the .do file

requests the alpha value to be applied for a specific analysis.  I would
like to run the file and then enter an alpha value at will using the command

on the console.

I am using the display _request command.  Execution of the command stops the

.do file, as it should, awaiting the entered value for alpha.  After I enter

the alpha value, the .do file runs to completion perfectly except it always
uses an alpha value which I had previously entered.  If I start anew with a
fresh STATA session, running the .do file, even after entering a value at
the prompt, results in the error message "alpha not found".

Obviously, the value I am entering on the console is not being preserved by

Any help?


*   For searches and help try:

*   For searches and help try:

__________ Information from ESET NOD32 Antivirus, version of virus signature 
database 4831 (20100203) __________

The message was checked by ESET NOD32 Antivirus.

*   For searches and help try:

© Copyright 1996–2020 StataCorp LLC   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index