Statalist


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: RE: Stata crashes after dropping filter variable while editor is open


From   "Martin Weiss" <[email protected]>
To   <[email protected]>
Subject   st: RE: Stata crashes after dropping filter variable while editor is open
Date   Wed, 12 Aug 2009 22:46:30 +0200

<>

Same happens on my end. Teething problem...


HTH
Martin


-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Allan Joseph Medwick
Sent: Mittwoch, 12. August 2009 22:34
To: [email protected]
Subject: st: Stata crashes after dropping filter variable while editor is open

Hi, All,

I had my data editor open with a filter applied when I dropped one of
the variables on which the filter was based.  Stata then proceeded to
crash.  You can replicate this by following the below steps:

sysuse auto
editor
* manually apply a filter for example foreign == 1 and return to the
command prompt without closing the data editor
drop foreign

The "Stata has stopped working" error message pops up.  It would seem
like it would make more sense for Stata to check if the variable is
being used as a filter and prevent it from being dropped in the first
place or removing the filter first and then dropping.

Sorry if this is a known issue.

Thanks!
Allan

-- 
Allan Joseph Medwick
Doctoral Student, Higher Education Management
University of Pennsylvania
Telephone: 267.234.7972
*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/



*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/



© Copyright 1996–2024 StataCorp LLC   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index