 |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
st: RE: Is it possible to create tornado diagrams in Stata?
|
From |
"Forshee, Richard" <[email protected]> |
|
To |
<[email protected]> |
|
Subject |
st: RE: Is it possible to create tornado diagrams in Stata? |
|
Date |
Wed, 8 Apr 2009 18:02:39 -0400 |
Richard A. Forshee, Ph.D.
Senior Risk Assessment Expert
Office of Biostatistics & Epidemiology
FDA - Center for Biologics Evaluation and Research
1401 Rockville Pike HFM-210
Rockville, MD 20852
Phone: (301) 827-6042
Fax: (301) 827-3529
E-mail: [email protected]
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Eldon
Spackman
Sent: Wednesday, April 08, 2009 4:48 PM
To: [email protected]
Subject: st: Is it possible to create tornado diagrams in Stata?
I am undertaking a one-way sensitivity analysis and would like to report
the effect of an input range on the result. I have a table of a range
in results for each input and would like to display this graphically
using a tornado diagram. Any suggestions of how this might be
accomplished would be very helpful.
Thanks.
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/