Hi,
I am using relogit in one of my papers. I run the same model with three different dependent variables. I works just fine with one of them. But, it doesn't work with the other two, which are no more than subsets of this first variable.
I get the following error messages:
1.
conformability error;
You have issued a matrix command attempting to combine two
matrices that are not conformable, for example, multiplying
a 3x2 matrix by a 3x3 matrix. You will also get this message
if you attempt an operation that requires a square matrix and
the matrix is not square.
However, I know it is a similar matrix with the one that works. The variables do not change, but the dependent one which also takes values 0 and 1 just like the one that works.
2.
matrix has missing values;
You have issued a matrix command attempting a matrix operation
that, were it carried out, would result in a matrix with missing
values; dividing by zero is a good example.
This is a little more perplexing. The model is the same. There is no missing data.
Any suggestions?
Ada Hyso, Doctoral Candidate
Department of Political Science
University of Wisconsin-Milwaukee
Milwaukee, WI 53201
Fax 414-229-5021
E-mail: [email protected]
*
* For searches and help try:
* http://www.stata.com/help.cgi?search
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/
