Statalist


[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]

Re: st: keep


From   Erik Bihagen <[email protected]>
To   [email protected]
Subject   Re: st: keep
Date   Mon, 10 Sep 2007 13:41:20 +0200

Thanks,

but i tried that. The problem is that the result of -capture keep v1 v2 v3 - is that the command is disregarded. As an example; I want to keep v1, and v2, but not v4 for data sets where v1, v2 and v4 are present (and run the same command for all other data sets I have, see below)

/Erik

Sebastian F. B�chte wrote:

Erik

try -capture keep v1 v2 v3-.

regards
Sebastian

2007/9/10, Erik Bihagen <[email protected]>:

Hi Statalisters,

Is there a way to let the keep command do the following?
I want to keep, let's say, three variables v1 v2 v3 before saving data,
but all these three variables do not exist in all data sets for which I
want to run the command (I want to do this with a loop using many data
sets and I use global to define the variables).

I could drop variables instead using "capture drop v4" etc, but that
would become a very long do file.

Cheers

Erik

--
Erik Bihagen
Swedish Institute for Social Research
Stockholm University
SE-106 91 Stockholm
Phone: +46 8 16 26 51
Fax: +46 8 15 46 70


*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/

*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/


*
*   For searches and help try:
*   http://www.stata.com/support/faqs/res/findit.html
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/



© Copyright 1996–2024 StataCorp LLC   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index