Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down on April 23, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: st: Modeling % data


From   "Michael I. Lichter" <MLichter@buffalo.edu>
To   statalist@hsphsun2.harvard.edu
Subject   Re: st: Modeling % data
Date   Thu, 23 Sep 2010 14:38:27 -0400

Maarten,

Thank you for making your presentation available. Is it possible to make a single-page-per-slide version available, too? That is, one that's not 72 pages long for 20 slides! Thanks.

Michael

On 9/22/2010 11:51 AM, Maarten buis wrote:
This all depends on how close your dependent variable gets to the boundaries of 0% and 100%. If the data stays well within the range of
20%-80% than I would have no problem using either -qreg- or just regular
-reg-. However, when you have observations that get close to these
boundaries, you'll probably want to take them into account. For that
there is a whole suite of commands available, which I discussed at the
last German Stata Users' Group meeting:
<http://ideas.repec.org/p/boc/dsug10/04.html>
*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index