Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down on April 23, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: st: Exporting ivreg2 results in a simple long table


From   Maarten buis <maartenbuis@yahoo.co.uk>
To   statalist@hsphsun2.harvard.edu
Subject   Re: st: Exporting ivreg2 results in a simple long table
Date   Thu, 20 May 2010 14:00:16 +0000 (GMT)

--- On Thu, 20/5/10, Chuck Cleland wrote:
>   I am using ivreg2 in combination with a "by" prefix
> command as follows:
> 
> by imp: ivreg2 mydv mycov (endotx = myinstru) , ffirst
> 
>   This works fine, but I would like to save the
> resulting coefficients and standard errors in a simple,
> long table. <snip> Then I would like to export the table
> to a *.dta or plain text file.

Sounds like a case for -statsby-, see -help statsby-.

Hope this helps,
Maarten

--------------------------
Maarten L. Buis
Institut fuer Soziologie
Universitaet Tuebingen
Wilhelmstrasse 36
72074 Tuebingen
Germany

http://www.maartenbuis.nl
--------------------------


      

*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index