Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down at the end of May, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: system limit exceeded you must drop models in Stata 11


From   Molly Lipscomb <molly_lipscomb@yahoo.com>
To   statalist@hsphsun2.harvard.edu
Subject   st: system limit exceeded you must drop models in Stata 11
Date   Thu, 11 Mar 2010 12:57:05 -0800 (PST)

Hi,
I recently started using Stata 11.  I've been running regressions, using est store, and then looking at them in tables, but if I run more than about 50, I've been getting the error message system limit exceeded you must drop one or more models.  I've tried using clear results and drop _est*, but neither of these seem to work--I just get the same message if I try to run any more regressions.  The only solution I've found to this problem has been to close and reopen Stata.  I've never had this problem  before in Stata 9 or 10.  
Any ideas on what I'm doing wrong?
Thanks!
Molly

*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index