Statalist


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: "svyset" for multistage sampling


From   Hisako Kobayashi <[email protected]>
To   [email protected]
Subject   st: "svyset" for multistage sampling
Date   Fri, 6 Mar 2009 23:44:00 -0800

Dear Statalist,

I have survey data collected through multistage cluster sampling with
stratification.  I have a question about command of ?svyset.?

For my data, first, the population was stratified and several clusters
were randomly selected for each stratum.  After that, different
sampling methods were used for selected clusters.  For some clusters,
sub-clusters were selected and then for each sub-cluster, individuals
were randomly selected. But for some cluster, individuals were
selected without selecting sub-clusters.  Moreover, some sub-clusters
were stratified and individuals were selected. In short, strata have
different stages and some have within-stratification (like below).

-Stratification ? clusters ? sub-clusters ? sampling
-Stratification ? clusters ? sampling
-Stratification ? clusters ? sub-clusters ? stratification ? sampling

In this case, I think that the command for multistage design like
below cannot be used for my data.
        svyset su1 [pw=pwt], fpc(fpc1)                        ///
               || su2, strata(strata2) fpc(fpc2) || _n, fpc(fpc3)

Instead, I guess I should have the command like...

       svyset [pweight=pwt], psu(su1) strata(strata1)...(without fpc)

I would like to know whether this is correct.
Thank you very much for your advice in advance.

Hisako



*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/



© Copyright 1996–2024 StataCorp LLC   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index