Stata The Stata listserver
[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]

Re: st: Parameters returned by -lincom- after -logistic-


From   Richard Williams <Richard.A.Williams.5@ND.edu>
To   statalist@hsphsun2.harvard.edu
Subject   Re: st: Parameters returned by -lincom- after -logistic-
Date   Sun, 08 May 2005 13:05:15 -0500

At 06:48 PM 5/8/2005 +0100, Roger Newson wrote:
Thanks to Richard for warning us about this little quirk re -lincom- after -svy- commands in Stata 8. This is controlled by the undocumented Stata 8 command -is_svy-, which you can find out about by typing

whelp is_svy
Thanks Roger. It is there in Stata 9 as well (hopefully it works with the new svy prefix?):

http://www.stata.com/help.cgi?is_svy

I wonder if this new svy prefix approach will cause potential problems for old post-estimation commands, e.g. if you had a post-estimation command for -logit-, could it potentially have problems if you had run -logit- with the svy prefix? Or for that matter, with new programs, perhaps you need to check if svy has been used if that will affect how your program operates. I'll be glad when I get Stata 9 in a few weeks and can stop asking and just check these things out for myself.


-------------------------------------------
Richard Williams, Notre Dame Dept of Sociology
OFFICE: (574)631-6668, (574)631-6463
FAX: (574)288-4373
HOME: (574)289-5227
EMAIL: Richard.A.Williams.5@ND.Edu
WWW (personal): http://www.nd.edu/~rwilliam
WWW (department): http://www.nd.edu/~soc

*
* For searches and help try:
* http://www.stata.com/support/faqs/res/findit.html
* http://www.stata.com/support/statalist/faq
* http://www.ats.ucla.edu/stat/stata/




© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index