1 item has been added to your cart.

Why don’t my community-contributed estimation commands work in Stata 11 or Stata 12?

As of Stata 11, variables are no longer dropped because of collinearity. Instead, these variables are omitted and are labeled with the “o.” operator in the column names of the resulting parameter vector. Also, factor variables are now allowed in most official Stata commands and older, community-contributed commands do not support the new features.

These two additions will affect community-contributed commands and may cause the commands to return an error message. Until the author of the command updates the command to allow factor variables and handle the new collinearity behavior, a work-around is required.

Common error messages that may be displayed when a command does not allow factor variables or understand the new omitted operator include the following:

factor variables not allowed
r(101);

interactions not allowed
r(101);

varname#0b:  operator invalid
r(198);

factor variables and time-series operators not allowed
r(101);

i.varname invalid name
r(198);

o.rep78 invalid name
r(198);

_i.varname invalid name
r(198);

_o.varname invalid name
r(198);

If you receive an error message similar to the above, the community-contributed command has not been altered to work with the features introduced in Stata 11. Below are the solutions to working around this issue:

Collinearity

If your model contains collinear terms that are omitted and your community-contributed command is complaining about the “o.” notation, then the solution is to run the estimation command under version control. For example, instead of typing

regress y x1 x2 x3 x4 x5

type

version 10.1: regress y x1 x2 x3 x4 x5

This will run the estimation command as it ran in Stata 10.1. If you are able to remove the collinear terms manually from your model, then you can reduce your independent variables so that none are omitted and run the estimation command without version control.

Factor Variables

The new factor-variable features are NOT supported under version control. This is because they are features introduced in Stata 11 and do not work in previous versions. Thus the above solution for collinearity will not work for factor variables. You will need to use the xi prefix if the community-contributed command does not allow factor variables. For example, instead of typing

regress y i.factor

type

xi: regress y i.factor

Factor variables and collinearity

If your estimation model contains both factor variables and collinearity, you will need to use the xi prefix along with version control for the community-contributed command to work. For example, instead of typing

regress y x1 x2 x3 x4 i.factor

type

version 10.1: xi: regress y x1 x2 x3 x4 i.factor

For authors who want help on allowing these new features in their commands, see the following FAQ:

How do I modify an ado-file created for previous versions of Stata to support factor variables and the collinearity behavior introduced in Stata 11? (http://www.stata.com/support/faqs/programming/factor-variable-support/)