Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down on April 23, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: Storing Successive Lincom Results


From   "Ben Hoen" <bhoen@lbl.gov>
To   <statalist@hsphsun2.harvard.edu>
Subject   st: Storing Successive Lincom Results
Date   Tue, 5 Mar 2013 18:03:11 -0500

Hi all,

I hope this is a relatively easy question...

I have set up an ado file to run through a variety of regressions using
different model parameters and different datasets.  For each regression the
set of coefficients of interest are the same, and, for each regression, I
calculate a test of a linear combination of three of the coefficients of
interest.  

Although it is relatively easy to store the regression results for later use
(using eststo) I would also like to store the results of the linear
combination test, especially the point estimate and the se.

Is there a way to append the results for each lincom test to a file to be
used later, after the entire ado file runs?  

If you have suggested reading or insights I would be very appreciative.
Thank you in advance,

Ben

Ben Hoen
Principal Research Associate
Lawrence Berkeley National Laboratory
Office: 845-758-1896
Cell: 718-812-7589
bhoen@lbl.gov
http://emp.lbl.gov/staff/ben-hoen

Visit our publications at: 
http://emp.lbl.gov/reports/re




*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/faqs/resources/statalist-faq/
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index