Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down on April 23, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: RE: r(1000) error when running xi


From   Nick Cox <n.j.cox@durham.ac.uk>
To   "'statalist@hsphsun2.harvard.edu'" <statalist@hsphsun2.harvard.edu>
Subject   st: RE: r(1000) error when running xi
Date   Mon, 31 Oct 2011 12:09:12 +0000

Also, -xi:- is not needed in Stata 11, given the introduction of factor variables. 

Nick 
n.j.cox@durham.ac.uk 

A Loumiotis


I get the following error when I run xi:

system limit exceeded - see manual
r(1000);

I modified a bit xi and measured the length of the local orig and
found out that the error occurs when the macro length of orig exceeds
165198.  I'm surprised because I'm not using Stata/IC where the macro
limit is 165,200 but I'm using Stata/MP where the macro limit is
1,081,511.  Do you know why this is happening?

My version of Stata is the following:

.about
Stata/MP 11.2 for Windows (32-bit)
Born 01 Sep 2011
Copyright 1985-2009 StataCorp LP

Total physical memory:     2097151 KB
Available physical memory: 1726136 KB


*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index