Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down on April 23, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: posting results after qreg


From   Josepedro Gonzales <josepedro1017@yahoo.com>
To   "statalist@hsphsun2.harvard.edu" <statalist@hsphsun2.harvard.edu>
Subject   st: posting results after qreg
Date   Sat, 16 Jul 2011 23:31:20 -0700 (PDT)

Hello Statalist Users, 

I would like to post the regression results of a quantile regression with a new estimation of the var-covar matrix I created (V1). To do this after "regress" instead of "qreg" I would do 


ereturn repost V = V1
reg

, and I would get the same output that comes after regress but using V1 instead of V. This very same command doesn't work after qreg. I get the 
message "last estimates not found". The closer I got is to use "esttab, se wide" which gives the coefficients and se, but I would like to have all the output (pvalues, CI etc) that comes after qreg. Any ideas?

Thanks for your help!
Jose Pedro
*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index