Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down at the end of May, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: st: irr in ZINB command


From   Ari Samaranayaka <ari.samaranayaka@ipru.otago.ac.nz>
To   <statalist@hsphsun2.harvard.edu>
Subject   Re: st: irr in ZINB command
Date   Wed, 22 Jun 2011 11:45:10 +1200

Maarten
Thank you very much Maarten. Question fully answered.
Ari

On 21/06/2011 8:15 p.m., Maarten Buis wrote:
On Tue, Jun 21, 2011 at 8:59 AM, Ari Samaranayaka wrote:
I am using ZINB command. For count model in this command we can get IRR
using irr option, but not for zero-inflated model of the command. Is there
any reason not to produce IRR for zero-inflated model? If  not does anyone
know how to get IRR for the zero-inflated model too ?
The inflate part of -zinb- uses (by default) the logit link function ,
so incidence rate ratios do not make sense for the inflate part. You
could get odds ratios. You can get those by typing -est table , eform
b se- after you estimated your -zinb- model.

Hope this helps,
Maarten

--------------------------
Maarten L. Buis
Institut fuer Soziologie
Universitaet Tuebingen
Wilhelmstrasse 36
72074 Tuebingen
Germany





*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index