Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down at the end of May, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: st: Stset_error_factor variables and time series not allowed


From   Sanam P <sanamp25@yahoo.com>
To   statalist@hsphsun2.harvard.edu
Subject   Re: st: Stset_error_factor variables and time series not allowed
Date   Sat, 21 May 2011 19:47:18 -0700 (PDT)

Please ignore my below question.I realized that I hadn't put any space between 
time and . in the exit command, and this was causing the error.

Cheers,
Sanam 



----- Original Message ----
From: Sanam P <sanamp25@yahoo.com>
To: statalist@hsphsun2.harvard.edu
Sent: Sat, May 21, 2011 5:53:31 PM
Subject: st: Stset_error_factor variables and time series not allowed

Dear Stata list members

I have received below error after running a simple stset command in Stata11. I 
have recently installed updates from stata.com, could it be the reason?

Any help would be greatly appreciated.


stset time1, failure(censor) exit(time.) id(ID) enter(time0)

Error:
factor variables and time-series operators not allowed
r(101);


 
Many thanks,
Sanam

*
*  For searches and help try:
*  http://www.stata.com/help.cgi?searchhttp://www.stata.com/support/statalist/faqhttp://www.ats.ucla.edu/stat/stata/


*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index