Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down on April 23, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: Using Stata's "test" post-estimation command to perform comparisons after multiple-equation estimation


From   "Weichle, Thomas" <Thomas.Weichle@va.gov>
To   <statalist@hsphsun2.harvard.edu>
Subject   st: Using Stata's "test" post-estimation command to perform comparisons after multiple-equation estimation
Date   Tue, 24 Aug 2010 16:28:31 -0500

Hi Statalisters,
I'm trying to use Stata's "test" post-estimation command to perform
comparisons after multiple-equation estimation.  The comparison I want
is to test the equivalence of variable X contained in two different
logistic regressions.  There is a help section for "test" which
describes the use of the "sureg" command to set up the comparison.
However, it doesn't appear that "sureg" can be used with logistic
regression.  Does anyone have any experience with this situation?

Tom Weichle
Math Statistician
Center for Management of Complex Chronic Care (CMC3)
Hines VA Hospital, Bldg 1, C202
708-202-8387 ext. 24261
Thomas.Weichle@va.gov 

*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index