Bookmark and Share

Notice: On March 31, it was announced that Statalist is moving from an email list to a forum. The old list will shut down on April 23, and its replacement, statalist.org is already up and running.


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

st: RE: how to let STATA display values(coefficients) of panel-specific AR(1)


From   "Martin Weiss" <martin.weiss1@gmx.de>
To   <statalist@hsphsun2.harvard.edu>
Subject   st: RE: how to let STATA display values(coefficients) of panel-specific AR(1)
Date   Wed, 26 May 2010 17:34:33 +0200

<>

Type -ereturn list- after estimation to see the results available. The
manual entry describes each result in detail in its "Saved Results" section.
Maybe you want -mat l e(Sigma)- or -di e(rho)-?

HTH
Martin

-----Original Message-----
From: owner-statalist@hsphsun2.harvard.edu
[mailto:owner-statalist@hsphsun2.harvard.edu] On Behalf Of Xuxin Yu
Sent: Mittwoch, 26. Mai 2010 17:26
To: statalist@hsphsun2.harvard.edu
Subject: st: how to let STATA display values(coefficients) of panel-specific
AR(1)

i used xtgls with corr(psar1) to allow panel-specific autocorrelation.
however, the output doesn't show the values(coefficients) of
panel-specific AR(1). is there an option i can add to the syntax so
that i can see the values(coefficients)? thank you.
*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/

*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/


© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   Site index