Statalist


[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]

Re: st: too many variables


From   "Sergiy Radyakin" <serjradyakin@gmail.com>
To   statalist@hsphsun2.harvard.edu
Subject   Re: st: too many variables
Date   Fri, 29 Aug 2008 13:35:38 -0400

Thank you Kit, it's my fault.

When I asked this question 4 weeks ago, nobody responded, so I assumed
this was true. http://www.stata.com/statalist/archive/2008-08/msg00154.html

QUOTE:
"Which error codes are reserved for Stata use? Is there a full list of
these codes (and messages if possible)? Which codes may a Stata
programmer use for his/her own commands?"

Regards, Sergiy



On 8/29/08, Kit Baum <baum@bc.edu> wrote:
> < >
> Sergiy asserted
>
> Since Stata does not
> provide a list of all defined error codes, there is no easy way of
> knowing how to generate a particular error message.
>
> That annotated list appears in [P] error.
>
>
> Kit Baum, Boston College Economics and DIW Berlin
> http://ideas.repec.org/e/pba1.html
> An Introduction to Modern Econometrics Using Stata:
> http://www.stata-press.com/books/imeus.html
>
>
> *
> *   For searches and help try:
> *   http://www.stata.com/help.cgi?search
> *   http://www.stata.com/support/statalist/faq
> *   http://www.ats.ucla.edu/stat/stata/
>
*
*   For searches and help try:
*   http://www.stata.com/help.cgi?search
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/



© Copyright 1996–2014 StataCorp LP   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index