[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]
Re: st: Questions on gologit2 (fitstat and test [mleq1=mleq2])
At 08:03 AM 9/27/2005, Herve STOLOWY wrote:
-fitstat- does not currently work with -gologit2-. Add the -v1-
parameter to -gologit2-, e.g.
I have two questions concerning -gologit2- (downloadable from SSC).
I have used -gologit- several times with the following commands:
xi, prefix(): gologit format size1 auditor_d standards_d for_list
lev2 sales_int3 i.gics4
With -gologit2- and the same command lines, I get two error messages:
. After -fitstat-: "-fitstat- does not work with the last model estimated".
. After test [mleq1=mleq2]: "equation mleq1 not found".
I read the help file of -gologit2- but I can't find the equivalent
of the above commands. I am sure that I miss something, but my level
of understanding is not good enough.
xi, prefix(): gologit2 format size1 auditor_d standards_d for_list
lev2 sales_int3 i.gics4, v1
That should solve both your problems; if not get back to me. Also,
for -test- commands, you can refer to equations by their number, e.g.
That tends to be safest because you don't have to worry about how the
equations are labeled. In gologit2, the default is to use the value
labels of y for the equation labels, whereas in -gologit- the default
is to label them mleq1, mleq2, etc.
Incidentally, there is more info on gologit2 at
The troubleshooting FAQ is at
Richard Williams, Notre Dame Dept of Sociology
OFFICE: (574)631-6668, (574)631-6463
WWW (personal): http://www.nd.edu/~rwilliam
WWW (department): http://www.nd.edu/~soc
* For searches and help try: