Stata The Stata listserver
[Date Prev][Date Next][Thread Prev][Thread Next][Date index][Thread index]

Re: st: Using mlogit estimates


From   Christian Hunkler <[email protected]>
To   [email protected]
Subject   Re: st: Using mlogit estimates
Date   Tue, 10 May 2005 16:23:26 +0200

Hello again,

i forgot the crucial point,
you need to use [X]_b[varname], whereas you set X to the respective
outcome, as shown in the results.
Chris

At 13:32 10.05.2005, you wrote:
>Hello,
>
>I am trying to use the estimates from a mlogit regression output to
>calculate the probabilities of three outcome using different data.  When I
>type in "ereturn list" after the mlogit command is run, the matrix of the
>estimates referenced by e(b): 1x32 is listed.  Is there anyway to
>reference the coefficients individually to perform a calculation such as
>this one:
>
>Pr(y=2) = exp(XB2)/(1+exp(XB2)+exp(XB3))
>
>where XB2 and XB3 are the set of estimates for each respected outcome
>times its respected value.
>
>Thank you,
>
>Tonya Cropper
>PhD Candidate in Public Policy
>Harvard University
>617.493.9601
>
>*
>*   For searches and help try:
>*   http://www.stata.com/support/faqs/res/findit.html
>*   http://www.stata.com/support/statalist/faq
>*   http://www.ats.ucla.edu/stat/stata/
>


*
*   For searches and help try:
*   http://www.stata.com/support/faqs/res/findit.html
*   http://www.stata.com/support/statalist/faq
*   http://www.ats.ucla.edu/stat/stata/



© Copyright 1996–2024 StataCorp LLC   |   Terms of use   |   Privacy   |   Contact us   |   What's new   |   Site index